TITEBOND CONCRETE REPAIR SEALANT


Titebond Concrete Repair is a flexible, acrylic latex formula specifically designed for repairing and sealing cracks in steps, patios, driveways, sidewalks and mortar joints. Its excellent adhesion and flexibility will not peel, chip, crack or pull away from repaired areas. It provides an air-tight, weather-resistant seal that helps...

more

Features & Benefits

check_circle
IDEAL FOR: Sealing cracks in steps, patios, driveways, sidewalks and mortar joints.
check_circle
SEALS: Concrete, stucco, metal, masonry, wood and most common building materials.
check_circle
Fills and seals cracks in concrete & masonry
check_circle
Durable - Resists oil, gas, grease & salt
check_circle
Textured formula blends with surface
check_circle
Extrudes easily, excellent adhesion
check_circle
Weather-resistant seal
check_circle
Mildew resistant
check_circle
Paintable
check_circle
UV-resistant

Application Guidelines

Application Temperature:
Above 40°F (4°C)
Service Temperature Range:
-25°F to 180°F (-31°C to 82°C)
Method of Application:
Cartridge/caulking gun
Working Time:
Approximately 10-15 minutes for a 1/4" bead
Application Directions:
1. Surfaces must be clean and free of any material that may prevent adequate adhesion. Properly designed joint not to exceed 1/2" in width. 2. Cut tip at 45° angle to desired bead width and place in cartridge gun. 3. Force sealant into clean joint. If necessary, smooth bead immediately. 4. Do not allow foot or vehicular traffic on repaired area until it is completely dry. It is the sole responsibility of the user to thoroughly test any proposed use with all substrates to determine project suitability. NOTE: Two layers of Concrete Repair, 1/4” to 1/2” thick that are allowed to dry thoroughly between applications, are better than one heavy layer.
Cleanup:
Clean uncured material with water. After curing, excess sealant must be cut or scraped away.
Coverage:
Container 1/8” Bead 1/4" Bead 3/8" Bead 1/2" Bead
10.1 oz. Cartridge 123 ft. 31 ft. 14 ft. 8 ft.
Limitations:
Not designed for continuous submersion or use below the waterline. Air, sealant and surface temperature should be above 40°F. Do not apply if rain is expected within 12 hours. Cure time is dependent upon ambient conditions including temperature and humidity. The sealant should be dry to the touch and ready to paint in 2-4 hours. Allow to cure for 24 hours before direct contact with water. For best results, store in a dry location at or below 75°F.

Physical Properties

Type
Acrylic latex
Calculated VOC
<50 g/L (<1.5%)
Color
Gray
Solids
83%
Flashpoint
Solvent free/Not applicable
Viscosity
550,000 cps
Freeze / Thaw Stability
Stable
Storage Life
24 months in a dry location at or below 75°F

Specifications

Exceeds:
  • ASTM C834 Type OP Grade -18°C

Warranty Statement

Liability is limited to product replacement only.